Pickguard + Jackplate Template

Vintage Flying V´s were equipped with a 4-ply pickguard, either B/W/B/W or W/B/W/B can be found on 1958 Flying V´s.

Save money and make these yourself, using our Pickguard and Jackplate routing templates:

- precisely lasered
- all holes for mouting screws, right bridge post and toggle+pot holes are done
- material: 5mm birch multiply

During our research reg. vintage 1958 Flying V´s we camt to the conclusion that most probably two different sizes (diameter) of the jackplate were used: 43,8mm and 47,2mm. This set contains both sizes... your choice.

Center holes of the jackplate templates were done for pointing the center onto the plastic and drilling up.

-----

The 4-ply pickguard material for vintage Flying V pickguards you can find here.

Vintage tip:
The 4-ply pickguard was done with a 30° bevel and the 4-ply jackplates were cut with a 45° bevel.